Why corona takes place?
Answers were Sorted based on User's Feedback
Answer / chandu
due to the ionization around the conductor because of high
electric field intensity....
Is This Answer Correct ? | 4 Yes | 1 No |
Answer / shrishail
due to the ionization around the conductor because of high
electric field intensity....
Is This Answer Correct ? | 2 Yes | 0 No |
Answer / suresh
process by which a current,develops from an electrode with a
high potential in a neutral fluid, usually air, by ionizing
that fluid so as to create a plasma around the electrode.
The ions generated eventually pass charge to nearby areas of
lower potential, or recombine to form neutral gas molecule,
then produce a ight arround the conductor is known as
corona.......
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / yaswanth
Basically it happens due to 3causes.1)Bimetalic materials
which is connected together.2)weather position.3)The ele.
current which is passed through it is getting heat on the
conductor&it get release the ions arround it which is
created a layer on that.
Is This Answer Correct ? | 0 Yes | 1 No |
What conditions are required for transformer to operate at low frequencies ?
define as synchronous generator
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
What is mean by hormonics?
What is basic difference between Soft Starters And VFD drives?
how to calculate the earth mat design in 132 kv substation yard ????
0 Answers Divis Laboratories, KSEB, SWPL,
As per IS why should the control be taken only from R phase, why not from B or Y phase??!!
why zero sequence impedance measurement is not applicable for single phase GT
Why reverse relay used
I'm generating a pulse of 3V with frequency 80Hz (12.5ms time period) and pulse duration 0.125ms and feeding it to a transformer since i want the pulse to get amplified around 60V. At the output amplification s happening but the pulse is changed to a spike, can you tell me what could be the reason? (an ordinary transformer 220V-12V stepdown transformer is reverse connected ie. now it is 12V-220V stepup and voltage amplification happens)
we are using three transformer 33000/430 vac for three separet block.all three transformer have three LT panel separetly. can be Interconnected all three panel through bus coupler. this is permissable or not by state electricity board.
Can we see the poles in the motor?. if yes then how can we see plz tel me