Answer / nitin pulastya

See PLC is a "Programmable Control System" as Mr. J.santosh have already explained, but DCS is "Distributed Control System" means if ur system is distributed in many controllers but operated and controlled with single SCADA then such system is called DCS.

DCS is not a feature of Hardware but is the feature of software.

PLC is faster than DCS but with less I/O handling capability.
and PLC is used only in machine automation type system (like in Power plant for soot blowers, Cooling sys., in Cement plant RABH, Bag filter, Air blasters, Lubrication system, Girth gear etc).

DCS is mainly used in process.

Answer / j.santosh ramana kumar

see plc is the programmable logical controller, it is a
automation device which interface with computer for
automation purpoce , it is a soft-wired, hear no wiring is
required where we use relays .here we write ladder logic
where in dcs block diagrams are drawn

1 ph induction motor winding priniple and connection diagram?Similarly for 3 ph induction motor?Full description

0 Answers  

---

What is the Power factor of DC Power system ?

9 Answers  

---

Upto what extent, the lagging power factor can be improved with the help of capacitors?

6 Answers  

---

WHAT IS DIFFERENCE BETWEEN idmt and instentanous relay? is idmt is used as back up protection or else?or when instantenous relay saturates IDMT will operate???

1 Answers   BK, REL,

---

In a 3 phase squirrel cage induction motor why does rotor rotate? will 3 phase transformer rotate like a motor if it is placed on bearings and powered up? give reason

10 Answers   Siemens,

---

Which system is best for industries 3ph 3w or 3ph 4w?

3 Answers  

---

Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?

0 Answers  

---

Dear Sir, I willing to know if one 15Hp induction motor run in star connection. What happen power capacity of motor? Plz tell me.

1 Answers   Amtek Tekfor Automotive,

---

what is percentage impedance of transformer? explain its significance

2 Answers   ABC, Bosch,

---

why neutral and earth should not be connected on 3 phase 440v/50c/s supply at consumer side. where as on 25kv/ac/50c/s railway traction substation neutral and earth will be connected and track at substation. and track will act as neutral and earth. Reasons for this is needed urgently

4 Answers  

---

What is the minimum load that you can keep in a 3 Phase 40 KVA Diesel Generator? Is it neccessary to load all the 3 phases? Can a phase be left without load?

2 Answers   DRDO,

---

how many safety really of DG sets.

0 Answers   MBD, Nerolac,

---