Interested to Buy Any Domain ? << Click Here >> for more details...
hello freinds what is advantage and disadvantage of plc
again dcs?
- 2 Answers
- 6810 Views
- I also Faced
- E-Mail Answers
Answer Posted / nitin pulastya
See PLC is a "Programmable Control System" as Mr. J.santosh have already explained, but DCS is "Distributed Control System" means if ur system is distributed in many controllers but operated and controlled with single SCADA then such system is called DCS.
DCS is not a feature of Hardware but is the feature of software.
PLC is faster than DCS but with less I/O handling capability.
and PLC is used only in machine automation type system (like in Power plant for soot blowers, Cooling sys., in Cement plant RABH, Bag filter, Air blasters, Lubrication system, Girth gear etc).
DCS is mainly used in process.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Transformer how to maintaince a check b check c check d check
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
Alternator rotor earth fault relay circuit
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
how to modify DOL control panel into Delta Y connection?
what is the function of gss in the dg set.
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
i have some screw comprressor with 630kw power,i have established them with simple star to delta circuit,by the way there is so much inertia when the screw comprressors start, can you offer me contactors power with 400vac or any cataluge to choose the contactors
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
What are the three major categories of error?
Why are iron cores in transformers made laminated?
