Answer / naresh

scouring is a process in which soft soil remove from near
the piers, due to the high stream flow.

Answer / moula

removing of softsoil on stream or any water place due to
high velocity of water

Answer / iamrk1293

Scouring can be defined as a process due to which the particles of the soil or rock around the periphery of the abutment or pier of the highway bridge spanning over a water body, gets eroded and removed over a certain depth called scour depth. Scouring usually occurs when the velocity of the flowing water increases or crosses the limiting value that the soil particles can easily handle.

Answer / royal civilians

its the act of water to clean the surface.....this
scouring improve the softness of soil...i.e
river .......i have studied it in applied geology.....

Answer / gowtham1993

removal of sediments such as sand and rocks around bridge abutement or piers

WHAT IS MEANT BY ZERO VALUE IN QUANTITY SURVEYING

1 Answers  

What is plate load test?

7 Answers  

08. 4 main points about check list for Shuttering works are––– 4 i) ii) iii) iv) 09. 4 main points about check list for Concreting works are––– 4 i) ii) iii) iv) 10. 4 main points about check list for Plaster works are––– 4 i) ii) iii) iv) 11. 4 main points about check list for Brick works are–– – 4 i) ii) iii) iv) 12. 3 main points about Project delaying factors are––– 3 i) ii) iii) 13. Write down 60-grade M.S. deformed bar specification. 3 14. 3000 psi concrete means: 1 15. 4 main points about methods of wastage control are–– – 4 i) ii) iii) iv) 16. 1 main point about reasons for your honesty is : 1 17. Water cement mixing in hopper less mixture machine is better than hopper mixture machine because: 1 18. 2 main points about your role during roof casting are–––– 2 i) ii) 19. a. The weight of 3333m deform bar of 24.5 mm dia is…… 1 b. The weight of 300 rft plain bar of dia 1 is……. 1 20. The types of slumps are––– 3 i) ii) iii) 21. 4 main points about the causes of cylinder failure are––– 2 i) ii) iii) iv) 22. Detection of a beam & a girder are–––– 2 i) ii) 23. Curing is needed for–––– 1 24. The types of slabs in respect of size & shape are––– 5 In respect of size: i) ii) In respect of Shape i) ii) iii) 25. The types of Column in respect of size & shape are–– – 9 In respect of size: i) ii) In respect of Shape: i) ii) iii) iv) v) vi) vii) 26. 3 field tests & 3 Laboratory tests of bricks are––– 6 Field tests: i) ii) iii) Lab test: i) ii) iii) 27. 2 field tests & 1 Laboratory tests of sand are––– 3 Field tests: i) ii) Lab test: i) 28. 1 field tests & 1 Laboratory tests of M.S rod are––– 2 Field tests: i) Lab test: i) 29. a. The % of water absorbs by brick chips: …………… 1 b. The % of water absorbs by Stone chips: …………… 1 30. In respect of design: 5 a. The % of strength gains by concrete in 28 days= b. The % of strength gains by concrete in 14 days= c. The % of strength gains by concrete in 07 days= d. The % of strength gains by concrete in 03 days= e. The % of strength gains by concrete in 28 days without curing =

3 Answers  

Given a selection of 28 day cube test results for concrete placed of design mix C 35 and not all of which are greater then 35 MPa, how does one decide if the concrete in place is satisfactory. Are there a minimum number of cubes that need to be tested to decide that?

2 Answers   RPS,

What do mean by freeway ?

1 Answers  

what is the silt(for sand) allowed persentage as per IS CODE B/W: PLASTER: CONCRETE :

6 Answers   Trident,

bridge design

4 Answers   L&T, Secon,

In block work seawalls what is the purpose of slip joints?

0 Answers  

What is density of crush sand and fine aggregate

1 Answers  

could u tell me how to used deform stell bar in reinforce concret?i wanna know the general using in the site!

0 Answers  

What is Joule Brayton Cycle?

0 Answers   Bechtel,

The place Chakri Dadri which was recently in news in located in______ place? A) Uttar Pradesh B) Uttarakhand C) Rajasthan D) Haryana

1 Answers   HPSSSB,