Answer / asif raza

MY DEAR FRIEND AS WE KNOW THAT, ALL GENERATOR ARE DESIGN TO PRODUCE THE POWER WITH LAGGING P.F,SUPPOSE IF WE INCREASE MORE EXCITATION CURRENT TO THE GENERATOR'S ROTOR FIELD, THE P.F WILL BECOMES LEADING & ARMATURE REACTION WILL TAKES PLACE DUE TO THE EFFECT OF STATOR FLUX ON ROTOR FIELD.SO YOUR AVR WILL LOSSES THE CONTROL OVER ALTERNATOR & YOUR WINDING WILL DAMAGE.

Answer / naveen

your question is confusing, specify lagging or leading.
if generator running in leading PF then increase exitating
to bring it to lagging region, because it is ment for
lagging power factor only

if it is running in leading then chances of generator
failure are more,but before that generator protection will
trip.

Answer / msalam_shahin

When generator is running in leading side then the
excitation current should decrease to improve the pf....

how to build a network which step down 415v to 1v rms

0 Answers  

---

selection of conductor in different voltage?

1 Answers   TATA,

---

how will protect transformer agint overcurrent protection

6 Answers   MPSEB,

---

why do MCB melt but not tripped in lighting highmast??

1 Answers   AHPCL,

---

Need help. 3 phase system. Neutral line arced and melted upon connection of connector with 3 phase power. Why would that happen?

4 Answers  

---

why we use condenser in the thermal power plant, althrough the same vapour will be again heated

2 Answers  

---

what is principle in relay testing kit?

3 Answers  

---

will 1050kva DG set withstand for back charge of 16MVA transformer

0 Answers  

---

How would you supply a single house hold load from a 3-phase supply coming out of a sub-station?

4 Answers   Power Grid,

---

what is field flash

4 Answers   Bhel,

---

generator(Deutz 550kv)is runing for 2 hours with load of 900 amp and then it goes in shutdown with alarm fault messege of speed fault although heirtz reading fixed at 50,what does that mean

1 Answers  

---

difference between relay and solenoid?

2 Answers  

---