Answer / karthic

relays are the device that give signal to the circuit
breaker during fault condition protecting the system from
further damage.

Answer / manjifera

its a device which control/protects the high voltage
equipments using low voltage which is safe for human.

Answer / motilal sahu

RELAY IS FAULT SENSING DEVICE.AFTER SENSING THE FAULT IT
SEND INFORMATION TO CIRCUIT BREAKER

Answer / kannan

Relay is the combination of NO & NC contact which will be
changed during energizaztion.

Answer / nagaraju .n

it is opperating & controllig divice depending on users

Answer / anindya chitta bagchi

relay is an electromechanical/electronic device,that picks up
when certain conditions are met,and then makes normally closed
contacts open,and normally open contacts closed.

Answer / ecstatic

Relay is a device used in protection system which senses
any abnormal condition in an electrical circuit and
triggers the trip coil \../
it can also be defined as an electromagnetic switch used to
control high voltage through low voltage ..

Answer / sush

Relay is like switch having Normaly open, Normaly close &
combination of both.In relay tere is electro magnetic coil
which is energized when supply is given and atract the
armature to make the contact.

Answer / hemant

relay is an sensing device. it senses the fault condition & energises the CB coil.

Answer / gunnam santosh

basically relays are coils designed for certain current
rating if current flowing through it increases this rating
it gets energised and operates the centrifugal switch placed
in it and opens the switch.

How can we get electric power from lighting ?

3 Answers   TATA,

Why transformer neutral earthing? What is advantages?

6 Answers  

Why NGR is provided in sub station?

4 Answers   MMS,

why transformer rated in KVA not in KW ? we know that W= v*i

6 Answers  

What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.

0 Answers   GNFC,

if 400kv line is connected to the load but neutral ii not be connceted then wt ll happen

1 Answers  

How to calculate cable size for a particular load? i have 12 MW,11KV Motor 3 Phase, what should be cablesize? What are the points to remember for cable sizing calculations?

2 Answers  

WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?

1 Answers  

how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???

0 Answers  

anti pumping relay function

3 Answers   Hofincons,

why the arc welding machines require parallel earthing systems? ie why each machines are connected to earth pit by separate wires during earthing? wats it adavantages?

0 Answers  

why the name mho relay,despite the locus of circle is impedance?

1 Answers   KSEB,