Answer / raj kumar & uday rao

110 VOLT

Answer / gaurav sinha

voltage is 3% to 5% lower than the nominal system voltage; for example, a nominal 208 V supply ...6.24 to 12.48..

Answer / velavan

line to neutral=230v
line to line = 440v

Answer / pitchaikannu

Electrical system voltage:110v
Electronic system voltage:3.2v

Answer / dhola mahesh

in a.c. its 220v
in d.c. its 1.5

Answer / hitesh tiwari

IN CASE OF AC SYSTEM
230VOLT(RMS)

IN CASE OF DC SYSTEM
24V(DC)

Answer / taufic

250 to 440

no of rotrs poles in salient pole synchronous machine

3 Answers  

WHAT MEANT BY SEVICE FACTOR?

2 Answers  

in ct secondary one terminal is connected to earth why?

1 Answers  

Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?

0 Answers  

Why carbon brush used in dc motor also why its not used in ac motor?

2 Answers   RRB,

what happen if turbine trip ,g.c.b not open and excitation on condition?

1 Answers  

how do the stepper motor works.

1 Answers   Vardhman,

How feedback transformer works to feedback power in Slip Power Recovery System

2 Answers  

Tell me how you are ready to comply with the employment rules and regulations if your CV is considered for employment?

0 Answers  

In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes

0 Answers  

What are the Safety Steps While Inspection the LT Panel.  

1 Answers  

what is the function of breather in a transformer

29 Answers   Areva, Bhel, RKM Powergen, Vijai Electricals,