Answer Posted / velavan
line to neutral=230v
line to line = 440v
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
WHAT IS LOAD CELL
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
what is load vs Torque curve & why it is used?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
What is meant by vector group
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
What is the estimated total hydropower potential of india?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
How much load can be taken for chiller from 1500 kva transformer
who can measure the size of power cable?
What are reasond for high wattage in single phase induction motors
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
difference between a diode and thyristor?