One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?

1 Answers  

---

what is differance bw ELCB and MCB. ?

3 Answers  

---

usually why bettery voltage are 1.5V, even if you open a 9V battery there are six 1.5V batteries in series. is it not possible to increase this voltage other than putting in series

1 Answers  

---

how one can check the Current of a DC 12 V battery ? Procedure. I told that take a thick wire (having more wires in it) and then join the + and - terminals of battery with the help of two ends of a thick wire .... is this correct or wrong .....

1 Answers  

---

If I have a LT panel 3ph, 415V, 50Hz which demand load-600kw, how we can calculate its body earth strip size.

1 Answers  

---

What is the operating range of voltage and current in grid supply in India?

4 Answers   BARC,

---

What exactly is meant by harmonics and harmonic current?? and what is skewing with regard to this??

2 Answers  

---

In my power station 220 volts dc battery set. they coneected 84th cell taped

1 Answers   KPTCL,

---

how can I check HT cable ?

2 Answers  

---

Why is the air gap between the pole pieces and the armature kept very small?

0 Answers  

---

What are the specifications for getting approval of Substation?

0 Answers  

---

any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.

0 Answers  

---