two transformer connected in parallel.tap change are different.if i want to on

two transformer connected in parallel.tap change are
different.if i want to on the buscoupler what happen?

Question Posted / amit

two transformer connected in parallel.tap change are different.if i want to on the buscoupler what..

Current sharing will be in the ratio of voltages i.e. more
the voltage higher the current

Is This Answer Correct ?

1 Yes

2 No

More Electrical Engineering Interview Questions

Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?

what is 'A' Check & 'B' Check ?

Interchange 7 and 6 ,÷and× 36×7+4-7×3

now a shunt motor is practically a constant speed motor , then how does it meet the increase or decrease in the load ?

what is the specific gravity of fully charged battery

what is the difference between CT and CVT in EHV Sub Stations

why Transformers power mentioned in KVA?. and why Generators and Motors power mentioned in KW?.

Why not connect relay Y phase for over current and earth fault

In a incandescent bulb, if the glass is punctured, and then power is supplied, the tungsten filament blows up with a flash.Why?

where can the transformer having vector group Yny0 be used??

How much pole motor can be desion for 415 volt ,50 hz.Power supply. in pratical condition . Prakash veer singh

Iin ESP why positive is grounded ? why not negative ?

For more Electrical Engineering Interview Questions Click Here