Answer / iamdon

The allowalable frequency variations in
India=+/- 3%
US=+/- 1%

The reason for this variation

1)In US, there is an adequate generation for matching the
load.
2)In US,there is surplus spinning reserves for emergencies.

In India,we are facing challenges in these areas.

Author:arbelectbit@yahoo.com

Answer / abhishek

+- 0.5 hz

Answer / deepak kumar

+- .5%

What is the formula to calculate the size of Aluminium and copper cable?

0 Answers  

---

(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)

0 Answers  

---

how to calculate the bus-bar size. give formula with description

1 Answers  

---

In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.

0 Answers   HAL,

---

What is disadvanage if power factor goes to in leading..?

0 Answers  

---

---

how to remover corona effect and hysteresis losses from contactor

0 Answers  

---

Why HT cable have only 3 core ?

10 Answers   Jindal, McDermott,

---

why we are using the 2 slope in differential relay?but in busbar differential we are using only one slope. what is the reason.

1 Answers  

---

can we amplify dc signals.how can it be done

4 Answers  

---

What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?

0 Answers  

---

what is difference between 3.5 core and 4 core cable

5 Answers   Havells,

---

why we using capacitor in single phase motor ?

14 Answers  

---