how to calibrate load cell

0 Answers   Siemens,

---

LADDER LOGIC Can any body state Logic on following condition Instructions to use 1-XIC 2-XIO 3-Output ONLY Program Push 1st button On - 1st lamp should On Then Push 1st button Off - 1st Lamp Should remain on Push 2nd button On - 1st lamp should Off and 2nd lamp should On Then Push 2nd button Off - 2nd Lamp Should remain on.

4 Answers  

---

in the pipe line if the control valve fails to respond to controller action,by what means we can stop the flow in the pipe line ?

9 Answers  

---

How does SmartPlant Instrumentation interface with physical design (3D modeling)?

0 Answers  

---

Difference between dcs and plc including date processing and architecture.

0 Answers  

---

given a processor batch of 1000 resistors moving on the conveyor belting in a large factory. the resistors is value at 10k ohms each but when the resistors reach the quality control, some of the resistor has been rejected caused by failure in manufacturing.the high quality measurement is used to determine the failure. describe the instrumentation terminology in measurement of a system above with explaining the important in:- -reliability -sensitivity -repeatability -precision -range -resolution -linearity -hysteresis -error -accuracy (answer must related to the scenario above)

0 Answers  

---

any one suggest me how to calculate percentage of air leakage with formula,

0 Answers   SSL,

---

what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..

0 Answers   Accer, Reliance,

---

what is span value and zero ? and how set ?

0 Answers  

---

please can anyone tell me in detail, what's mean by open loop and close loop?

6 Answers  

---

Where should we terminate the shield and why?

3 Answers   OPaL,

---

in i/o panel for digital ouput(do) how much power(in volts) we must give?

2 Answers  

---