What is difference between converter & transducers?

Question Posted / rohan

4 Answers
28058 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is difference between converter & transducers?..

Answer / mohammed yousuf

Be it transducer or converter, the job is same that is
conversion but depending upon the input and output we
received it is termed as transducer or converter....

Transducer converts non-electrical parameter like
pressure,temperature,etc to electrical parameter like
voltage and current... whereas converter converts electrical
to electrical only. Eg: voltage to current or current to
voltage converts

Is This Answer Correct ?

29 Yes

5 No

What is difference between converter & transducers?..

Answer / rajesh kumar

Which converts one form of energy( mechanical ,chemical
vibration) to other form (in to electrical energy)is called
transducer .example for the transducer are bellows bourdan
tubes which are primary transducers.
And coming to the converters it is also just like
transducer it also converts one form of energy to other
form examples of it are (v/i& i/i converters)means in this
converters we can measure the parameter of input & out put
side

Is This Answer Correct ?

10 Yes

7 No

What is difference between converter & transducers?..

Answer / sumit kulkarni.

Basically transducer converts Non-electrical energy into a electrical energy.Ex.-pressure converts into voltage or electrical parameter by a LOAD CELL.Output of transducer become so weak so that it must required amplifier to next stage.
Other hand Converter converts electrical energy into other form of electrical energy i.e.AC to DC converters or I to V converters.mainly converted energy proportional to input energy.
Simply we say that ALL CONVERTERS BECOMES A TRANSDUCERS BUT ALL TRANSDUCERS NOT BECOME A CONVERTERS.

Is This Answer Correct ?

5 Yes

3 No

What is difference between converter & transducers?..

Answer / abdus sattar mollah

Being totally technical,
Transducers=That converts non-electrical measarands into electrical parameter.
Converter=DC to DC changer.

Is This Answer Correct ?

4 Yes

5 No

Post New Answer

More Instrumentation Interview Questions

Why trim span ? How?

0 Answers

How to calibration of vibration probe

1 Answers Mina Al Ahmadi Refinery,

Level in tank under vacuum (Ex: Condensate Tank of Power Plant)is measured using D. P. type level transmitter. Tank is subjected to vacuum of 755mmHg. Is it possible to fill wet leg ( i.e. leg connected to top of vessel with low point of D. P. xmtr) with water?. Are there chances of water getting sucked under vacuum? if yes, what is the solution?

3 Answers

i want interview questions about PROCESS CONTROL INSTRUMENTATION , SENSORS AND TRANSDUCERS IF ANY BADY KNOW ABOUT THAT PLEASE SEND TO MY MAIL karumudi1003@gmail.com

8 Answers Honeywell, Reliance,

Why some transmitter shows flow in MMWC and some in TPH?

2 Answers

how to convert digital signal to analog signal in plc

1 Answers UltraTech,

can u please give the exact ckt explaination of AC Drive related to industries.

6 Answers

if a tank is contaning oil and water than how can we measure the oil and water level seperately

3 Answers

What is DCS?

4 Answers GAIL, Sabic, Trident, Yokogawa,

why we use sensing type(NPN)on a vibration monitring system not a (PNP)sensing type