Is there devices to convert mechanical energy/rotational energy into electrica

Categories >> Engineering >> Instrumentation
Suggest New Category

Is there devices to convert mechanical energy/rotational
energy into electrical energy.......?
PLease suggest me....

Question Posted / naru

6 Answers
11892 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Is there devices to convert mechanical energy/rotational energy into electrical energy.......? PL..

Answer / girish

generator which converts mechanical energy into electrical
energy...

Is This Answer Correct ?

25 Yes

1 No

Is there devices to convert mechanical energy/rotational energy into electrical energy.......? PL..

Answer / ripul

piezoelectric crystals convert mechanical
energy(eg:pressure)to voltage..

Is This Answer Correct ?

16 Yes

3 No

Is there devices to convert mechanical energy/rotational energy into electrical energy.......? PL..

Answer / pramod

windmill

Is This Answer Correct ?

10 Yes

1 No

Is there devices to convert mechanical energy/rotational energy into electrical energy.......? PL..

Answer / siddhant

turbines can convert it.. when turbine connected to generator

Is This Answer Correct ?

8 Yes

1 No

Is there devices to convert mechanical energy/rotational energy into electrical energy.......? PL..

Answer / u.nathan

piezoelectric crystals convert mechanical
energy(eg:pressure)to voltage and it also again convert
voltage to mechanical energy

Is This Answer Correct ?

6 Yes

1 No

Is there devices to convert mechanical energy/rotational energy into electrical energy.......? PL..

Answer / santhosh rapilane

tachometer

Is This Answer Correct ?

1 Yes

8 No

Post New Answer

More Instrumentation Interview Questions

In control valve there are two type of valve seat we can use metal to metal seat & soft seat.On this valve seat i have following doubt. 1)I have never seen practically the internal assembly of valve so my doubt is that basically weather the seat is soft seat or metal its basic MOC is same as valve body(SS or CS) only in soft seat we are using PTFE ring & place on valve seat & in metal this PTFE ring is not threr am i correct??????? 2)what are the common general rule for using metal to metal seat & soft seat,means its depend on process parameter like liquid,gas, steam & on valve leakage class.

1 Answers

describe yourself?

1 Answers TCS,

What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.

0 Answers TNPL,

differentiate different units of pressure like US & UK standards

1 Answers

How will you measure surface temperature of SUN?

2 Answers GAIL,

what is purpose of three way manifold valve using for dp transmitter

1 Answers

how the flow rate is measured from a pipe with the help of pressure?

1 Answers

what is the use of shield cable?

2 Answers

What is the differerence between hysterisis and linearity.

0 Answers CCIE,

what is the procedure of O2 analyser calibration?

3 Answers Thermax,

Decibel.

0 Answers CCIE,

If a normal magnetic type flow transmitter that can measure flow, temperature and show this parameters on field, is it possible by any means to get this (flow and temperature) parameters info. On dcs? And if yes then with HART, FO communication or any other communication system?

1 Answers Process Control Technologies,

For more Instrumentation Interview Questions Click Here