I work on a electronic positioner transmitter 4211 at the field.I connect my multimeter in series to get the current output then I calibrate it to 4ma in 0% of position of the valve and 20ma in 100% position of the valve.My problem is in the field I get the correct output current based on my multimeter but in the dcs they only receive 40% in a output 20ma of this positioner.Then I try to simulate in this analog card and they receive the equivalent percent on the value that I simulated.Is ther any possibility to reset the zero and span of this positioner 4211 fisher.And what other possibility I can do to fixed this.This is my email add ( landicho_randy@yahoo.com )

4 Answers  

---

Can anybody tell me the exact explanation for Functional calibration?When it should be done on process or on lab? Advanced Thanks

2 Answers  

---

State four different types of flow measurement.

4 Answers   ADMA OPCO,

---

How can I zero check of wet leg type DP Tx ?

6 Answers   ONGC,

---

What is Actuator?

3 Answers   Descon,

---

---

yokogawa Temperature transmitter showing Error 15 which is Reverse Cal Fail (confirmation calculation result is bad) in manual they mentioned reasion That the output goes to the value set by hardware failure mode jumper. How can solve this problem ? anybody can say solution

1 Answers   GTL,

---

what the differant between Wet Leg /Dry Leg

2 Answers   Sepam Group,

---

what is metal of piston ring

0 Answers   MahaGenco,

---

Sir i am studying M.sc,(Tech.)Electronics and Instrumentation in Andhra university.What is the offers for me?

4 Answers  

---

how to convert digital signal to analog signal in plc

1 Answers   UltraTech,

---

Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd

0 Answers  

---

what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...

0 Answers   Mittal Steel,

---