Answer / jignesh savani

8085 is 8 bit processor while 8086 is 16 bit processor.
4 to 20 MA is analog signal while switching (Short/Open or
1 / 0 ) is called digital signal.
Digital signal can define in terms of communication as a
no. of bits also but ultimetely its combinations of the two
staes 0 and 1

Answer / mohan manohar

continuously variation between 4-20ma, which is analog signal and On or Off states which is digital signals,

Answer / sasmita

electrical signal is the example of anlog signal

Answer / maddy

Example of Analog signal is 4-20mA, 0-10V.

Example of Digital signal is 0-24V.

Answer / jignesh

Analog signal that means ,from the field we r getting at
dcs system is 4- 20 ma (from ant types of control
valves,transmitters) is called ananlog signal.

Digital signals that means such as rtd,thermocuples(in mv)
is calleddigital signal.


8085 is old version of microprocessor and 8086 is a the
lattest version in year 2003,presently idont which version
of microprocessor is establish.if somebody know pls send me
ans.

where is a level displacer is used?

9 Answers  

The document / drawing that is primarily used in depicting the “Bill of Materials (BOM)” of piping system is the

2 Answers  

How to Calibrate Radar Level Transmitter in Field

0 Answers  

If i want use the 6 kg/cm2 pressure gauge then how to calculate its pressure gauge range?

1 Answers  

What is the use of gauge?

0 Answers  

how do i calibrate mmwc pressure guage with out calibrator.if any? pls give me the ans.

1 Answers  

Convert a pressure, level, flow, or temperature process variable value into the appropriate pneumatic or electrical value given different types of instruments.

6 Answers   Jindal, MCL, Thermax,

what is difference between HOT permit and cold permit

0 Answers   Petro Rabigh,

what is the primary sensing element in flow or pressureand level transmitter?

5 Answers   Power Grid,

draw the characteristics of chebyshev filter

0 Answers  

We have ZR22G-100-S-A-E-T-T--E-A/CV/F1 Model Zirconia Oxygen analyser which is Yokogawa make. I kept the analyser in Flue gas path at Air pre heater area. My plant is 7.5MW Biomass power plant. For a particular fuel, Coconut Husk which contains Sodium and Potassium chlorides iam not getting proper reading, Analyser output always Zero. I calibrated the analyser and it is OK. For Other fuels like Wood chips, Cholam waste, DOB, Groundnutshells, Ply wood waste and all iam getting actual percentage of Oxygen. What is the main reason behind this draw back?

2 Answers  

how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744

0 Answers