what are the ffactors you considered choosing the course?

0 Answers  

---

suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?

0 Answers  

---

What kind of tests will conduct in plastering

6 Answers  

---

IS sobha developers ,bangalore an good place to work for the freshers

5 Answers  

---

Why are the bolts that hold steel rails together in oval holes?

0 Answers  

---

how much quantity of cement and sand required for construction of 10 cum brick work( Brick size 3"*4"*9"(Standard size ) an d for 10 cum construction of SSM (Size stone masonary) with Cm 1:6 for both.

11 Answers   GRC, KEC, L&T, Techno Electric and Engineering, UPENN,

---

how to cal 1:4 in brick masonary work cement and sand?

1 Answers  

---

What is full form of r.c.c?

1 Answers  

---

What is mean by uniaxial bending

1 Answers  

---

we are roofing contractors,we are filling a bill in work contract 4.12% method, we collecting 4.12% from our customer but every month we have been paying the vat at 2% from our pocket on the total value of bill. our auditor told me the above method do not collect 2% from the customer side is it true?

1 Answers  

---

what is idealized curve for concrere and steel

0 Answers   BARC,

---

1) what do you mean by rolling margin of steel ? 2)pls. tell the cut length formula of stirrups as per IS codes(take out cut length for a beam of 600*300mm with 40mm cover all sides)? 3)what is the multiplying factor of painting for sand faced plaster? 4)if your footing is of size1.9*1.6m . what quantity of length and width you will excavate means what extra margins you will allow as per IS codes in billing?

1 Answers  

---