Answer / santosh singh

Lap length is the same generally 50d is taken.
Welding is provided only if the number of bars tied at a specific point in column are more than 50 percent

Answer / hiren vasoya

lap length is 47d where d is diameter of bar

what are RIB slabs explain about it

0 Answers   L&T, NCC,

---

difference between specification and method of statement

3 Answers   L&T,

---

What is the meaning of Brick- M 35 grade? Is it a common brick or it's a concrete brick?

0 Answers  

---

Why we provide hair pin for shed

0 Answers   ABC,

---

asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream

0 Answers  

---

WHAT IS THE % OF CONCRETE WASTAGES PERMITED IN A LARGE PROJECT ? AND WHICH IS CODE TO BE REFERED.

0 Answers   L&T,

---

How to check slab shuttering level.? Or check list for slab ?

0 Answers  

---

how you calculate the qty. of cement ,sand,aggregate from proportion 1:2:4 M15

5 Answers  

---

Why we use Reinforcement out side of the column not in centre

4 Answers  

---

1) what is the seewage discharge per person per day taken for design purpose as per IS codes? 2) how to convert gauge to MM like if we measure 18G as our door frame then how much is it in MM ? 3) how much binding wire is required ti tie 100kg steel ? 4) while making rings in steel reinforcement , whether the corners of rings are deducted to take out cutting length ? 5) how much carbon content should be there in steel used for construction purpose? 6) what are fe415 & fe 500 and which bars are used in general civil works?

1 Answers  

---

What is the lap lenth for welded joints for reinforcement bars. and what is its IS code no.

5 Answers  

---

mix design ratio of M30 concrete

1 Answers   KITL,

---