If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
No Answer is Posted For this Question
Be the First to Post Answer
Does voltage and current can be seperated?
why PD testing for power cables
1 Answers Bhushan Power Steel, CSE, Datre Corporation,
what are ABCD curves in MCBs and how we observe that curves?
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
what is the function of potential transformer in s/s
in single phase circuit if i connect a heater between phase and neutral, then what will be the current path? phase to neutral or neutral to phase.
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
What is the previous name of Cox's Bazar
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
what is pilot wire? what is the use of pilot wires?
what is difference between bus coupler and auto transfer switch
0 Answers Dubai Properties Group,
What is the si unit
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)