in single phase circuit if i connect a heater between phase and neutral, then w

in single phase circuit if i connect a heater between phase
and neutral, then what will be the current path? phase to
neutral or neutral to phase.

Question Posted / deep

4 Answers
6796 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

in single phase circuit if i connect a heater between phase and neutral, then what will be the curr..

Answer / sukhvinder

phase to neutral.

Is This Answer Correct ?

10 Yes

0 No

in single phase circuit if i connect a heater between phase and neutral, then what will be the curr..

Answer / masoom raza

As it is having ac nature therefore in both direction current will flow (as no diode is connected).

Is This Answer Correct ?

1 Yes

0 No

in single phase circuit if i connect a heater between phase and neutral, then what will be the curr..

Answer / ahamad kutty

SINCE AC IS ALTERNATE CURRENT IN EVERY HALF CYLE EACH
CONDUCTOR POLARITY IS CHANGED HENCE IT IS FROM PHASE TO
NEUTRAL FOR ONE HALF CYCLE AND FROM NEUTRAL TO PHASE NEXT
HALF CYCLE.

Is This Answer Correct ?

1 Yes

0 No

in single phase circuit if i connect a heater between phase and neutral, then what will be the curr..

Answer / syed ali raza naqvi

according to theory the path of current is phase to neutral
but a practically the current path is neutral to phase.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

why nutral and earthing wire connect with each other in main panel board.

2 Answers

a room heater is connected in serise with a 100w bulb.if the 100w bulb is replaced by a 40w bulb then the output of the heater is increase/decrease/remain same?

9 Answers College School Exams Tests,

i want to know how to determine that a surge arrester work properly in 11kv system. and how to test a 12kv surge arrester

0 Answers

What is the meaning of In,Io & Ir in Circuit breaker? How to calculate?

1 Answers

what is the difference between an alternator and a synchronous motor

0 Answers

How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?

0 Answers Tata Power,

what is use of reactive power in ac ckt.

2 Answers

What is primary distribution and secondary distribution of ac power?

3 Answers

why autotransformers are not safe for supplying low voltage from a high voltage source?

5 Answers

how to read AWG n how to convert AWG reading into mm?

1 Answers

What is Control & Relay Panel? And Remote Control Center?

0 Answers L&T,

In my project i am layout cables under the Maintainance bay /Maintainance yard in the TG Building. Whether in this route i can lay the H.T.Cables??? i am taking all H.T cables from the H.T Transformer to the TG Building..

1 Answers

For more Electrical Engineering Interview Questions Click Here