Answer / basanta ku parida

cable will puncher for many reason, i.e. m/c digging , jcb excavation for unknown area, surrounding the cable not protect properly so that outer load impact come to side

When two core (two Phase) are come into contact,the cable burst.
so that under ground cable go into depth 2.5 mt approx.otherwise laying in Hume pipe. Awareness of cable rout must known to all agency before working.

waht is the working principle of saft starter & what is the difference in vfd & saft starter

2 Answers   Cipla,

---

What is the difference between IS:1554 (Part 1)/1988 & IS:694/1990 ? What do these two standards specify about?

2 Answers  

---

in transmission line, if the load is suddenly increased at the receiving end of the system the phase shift will (a)decrease (b)becomems zero (c)increase (d)not be affected

4 Answers   Getco,

---

How to Calculate IKW(input kilowatt)of a Chiller plant

2 Answers   Voltas,

---

Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more

0 Answers  

---

---

why threre are two parallel lines in transformer's symbol?

11 Answers   NTPC,

---

In hydro plant,generally we install vertical hydro generators..why dont we recommend horizontal one??

1 Answers   Alstom,

---

In Designing the rating & accessories of a MCCB how to choose the type of releases..means what is the basis for selecting, thermal magnetic, electromagnetic & microprocessr based releases

0 Answers  

---

i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT

0 Answers  

---

What is drain current of static relay?

1 Answers  

---

An automatic water heater is an example of which type of control system?

0 Answers   GE,

---

In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?

0 Answers  

---