do we convert single phase line to three phase at minimum cost?

Question Posted / shivamsahays

1 Answers
3935 Views
I also Faced
E-Mail Answers

do we convert single phase line to three phase at minimum cost?..

Answer / k.prakashchandra

If specified ground clearance is available ,fix another 2
pin x-arm below the existing one.

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

how we calculate the motor rating of pump for water suction ?its any formula for that plz give thank u

3 Answers

In Ferantti Effect Receiving end voltage is greater than sending end voltage but how it is possible. I know its all about charging current but give me some more detailed explaination?

3 Answers

Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?

0 Answers

What is the Ideal Earth to Neutral Rating for Techonology Equipment like Routers, Switched, PABX, Computers etc etc?

2 Answers

Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?

0 Answers Accenture,

What will happen if v use DCP Type Fire Exingusher on a Server Chaisis???

1 Answers Emerson,

what is the meaning of knee point in current transformer and how to calculate?

2 Answers

How equivalent impedance is calculated in thevenin theorem?

0 Answers

Why squirrel cage motor can only use with low starting loads ?

0 Answers BEC,

what are the preventive maintanance actions taken for air circuit breaker? please answer me

0 Answers MAHINDRA,

Why a starter is used for a motor?

50 Answers L&T, Nilachal Polytechnic,

Efficient electrical earthing in hard rock area

0 Answers

For more Electrical Engineering Interview Questions Click Here