In power plant synchronizing time (synchroniging meter should be 12'o cloc

In power plant synchronizing time (synchroniging meter
should be 12'o clock position only. why not 6'o clock
position not possible.

Question Posted / venkatsri_1978

1 Answers
4053 Views
ITC Infotech, I also Faced
E-Mail Answers

In power plant synchronizing time (synchroniging meter should be 12'o clock position only. why..

Answer / k.prakashchandra

That is its normal position i.e. zero voltage position

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

what is the voltage regulation for unity and zero power factor?

0 Answers

While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply

2 Answers

How to calculate Busbar Thickness for Different type of HT/LT panels

1 Answers

how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)

0 Answers

How to reverse the direction of a DC motor ? By reversing the Armature wires or by reversing the field wires

2 Answers KFC,

How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.

0 Answers

how can we change the rotating direction of single phase AC induction motors?

12 Answers Heubach Colour, L&T, MNM Jain Engineering College,

what bridge circuit is used in Tandelta circuit

1 Answers

Why power factor should not be in leading (capacitive) mode of any load.

3 Answers GE,

in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?

0 Answers apspdcl,

what condition there autotransformer will fail?

2 Answers

kindly send me 11KV MV motor differential protection procedure by primary injection method.

0 Answers

For more Electrical Engineering Interview Questions Click Here