How to calibration of vibration probe
Answer / pravinsingh033@yahoo.com
Vibration probe is calibrated using Micrometer and TK-3 instruments. its depends on which type of vibration probe is used either Axial probe or Radial probe.
Axial probe- Bently Nevada TK-3 and
Radial probe- Micrometer.
This generally use to check the characteristics of the probe either it is healthy or not.
Is This Answer Correct ? | 1 Yes | 1 No |
What is the purpose of LO Overhead tank in turbines.
how to calibrate level transmitter
You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground
What is the Flow rate ?
WHAT IS INSTRUMENTATION?
Draw a group of instruments interlocked to a Pump & Motor?
what is upstream and downstream in liquid flow?
Who to difference between analog in & analog out in dcs?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
what is diffrence between cascade & three element system.
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
What is the difference between pt100, pt500 and pt1000 RTDs?