Answer / haridass

If there is zero error, the output will be minimum peak of
3.1 mA. If it like 2.2mA, the transmitter electronics may
be problem. Interchange with good transmitter and check.

Answer / shivu

it might have given the over range pressure at the time of
measurement /calibration, hence due to this it has moved to
the some different value ,,,,,,,,,,,

What is PID tunning

2 Answers   EID Parry, MFL,

---

what is remote mount with MTA option? (In case of Dual Sensor Vortex Flowmeter,rosemount has written in its catalog drawings).

2 Answers  

---

How to Calibrate Ultrasonic Level Transmitter in field

0 Answers  

---

what is span value and zero ? and how set ?

0 Answers  

---

what is droop in governer ,type of droop ,how it work

0 Answers   TATA,

---

How to work ultrasonic flow meter ?

1 Answers  

---

Draw block digram for well head from well to shipping pump?

0 Answers  

---

relation between flow and differential pressure.

7 Answers   ABB,

---

Difine flashing , Cavitaion & Noise? how to minimize these effects

3 Answers   L&T,

---

How to calibrate a orifice differential pressure flow transmitter in process?

1 Answers  

---

1.what is the effect of vapour presuure in orifice plate flow measurement 2.which is more effective 2 pressure sensors or one single differential pressure sensor in orifice plate measurement 3.how to design a v/i converter and i/v converter 4.how many type of thermocouple are there 5.how many leads are there in thermocouple measurement 6.how pressure sensors are connected in level measurement in differential pressure method 7.what is the output of capacitive pressure sensor (ac or dc),how its o/p is signal charactarized 8.what is the physical meaning of discharge coeeficient,why it is calculated,orifice plate what is its value,why it is less than 1,Q at upstream is equal to or not equal to Q at downstream of orifice plate why?what is vena contracta in orifice plate 9.why rotameter is called variable area flowmeter,it can measure flow even if area is not varying,why it is made tapered 10.design a 10 bit counter ,which counter you will prefer 11.how to remove self heating error in RTD 12.which is more sensitive pt100 or pt50 13.why thermocouple are connected in parallel 14.what is lead contact error in RTD,how to avoid 15.what is P,PI,PID,PD controller,why there is no ID controller 16.what is override,split range,sequential,ratio,feedforward,cascade controller 17.why we moved from SR to JK and then JK to master slave JK flipflop,give correct reason 18.how to measure level of a closed container which contains vapour and liquid,remember no vapour gas should be leaked,so ultrasonic and capacitive is not an option,design another method 19.how to design horse race counter including sensors and signal conditioning element 20.what is bevelling

0 Answers   BARC,

---

Boiler flame scanner working principle?

1 Answers   Bhel,

---