Answer / muhammed

first you calculat the load after that you calculate the current using this equation I= P/(ROOT3*V*POWER FACTOR)
after there is one cable selection table(available in google) using current rating check that cable and select the cable size

what is the function of a commutator in a dc generator?

14 Answers   College School Exams Tests, NTPC, TCS,

---

What is meant by (2 x 185) AYFY cable

3 Answers   ONGC,

---

what is the differences between single phase ind. motor and three phase ind.motor?

3 Answers  

---

When in a large power system if the demand of power is larger than the generated power the frequency of the power system drops.(assume the rated frequency is 50Hz and now it is 49Hz) So does this mean the demand is totally supplied with a lower value of generated power in a lower frequency?

1 Answers  

---

what is the most probable reason of failure of current transformer?

2 Answers   L&T,

---

How do you commission a power Transformer?

1 Answers   EEI,

---

how to calculate the bus-bar size. give formula with description

1 Answers  

---

What is meant by directional power and reverse power relay ?

1 Answers   HAL,

---

Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?

0 Answers  

---

how to commissioning the genset with amf panel?

0 Answers   Cummins,

---

why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?

0 Answers  

---

rajha power sector details

0 Answers  

---