Answer / hussain

http://www.flowmeters.com/coriolis-mass-technology
https://www.youtube.com/watch?v=XIIViaNITIw

Answer / swastikdjain@gmail.com

Coriolis principle

What is the detail function of I/O card in DCS ? Why we dont use the I/O directly with controller?

3 Answers   Kekran Mekran, TCE,

---

Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?

0 Answers   Process Control Technologies,

---

what is mass flow meter, working principle of mass flow meter and its installation.

2 Answers  

---

i want the equation of this question. Tranmitter range is 120 mmwc and dcs flow range is 1700 nm3/hr. if i want to change dcs range from 1700 to 2400 nm3/hr then how much dp i have to enter in transmitter

2 Answers   GMR,

---

why we are using 4-20ma why cant we use 4-40ma

3 Answers  

---

---

What is the difference between PLC and DCS?

3 Answers  

---

pls any1 sugges me book for plc,dcs & scada..

1 Answers  

---

What is Vena contracta?

3 Answers   CCIE,

---

What will the new flow factor if D/P Transmitter is RE-RANGED from 25" WC to 50" WC

3 Answers   ADMA OPCO,

---

what is the difference between PLC & DCS

17 Answers   L&T,

---

Yokogawa dcs normally where will change 4-20 MA to DC voltage( node or I/o cards?)

1 Answers  

---

why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.

0 Answers  

---