what is droop in governer ,type of droop ,how it work

0 Answers   TATA,

---

what is mass flow meter principal?

4 Answers   GIL,

---

In closed loop control there are several “blocks” used to show the interactions between the process and the control system. These blocks are referred to as the “process” and the “controller.” Describe the relationship between these two blocks when creating a well tuned control loop.

1 Answers  

---

What is T4 temperature in compressor?

1 Answers  

---

When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.

0 Answers   Chevron,

---

---

What is meant by calibration

5 Answers  

---

It is desired to reduce effect of 50Hz pick up in a thermocouple measurement. If a third order LP filter is used for this, what should be its cut off frequency, if gain should be 0.001 at 50Hz.

1 Answers   Honeywell,

---

how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.

0 Answers  

---

Why we. Don't measure current in parallel? Why we measure current in series and why we measure voltage in parallel only?

2 Answers   Almeer Technical Services,

---

i have 20 kw motor & my vfd drive capcity is 18 kw if possible to use 20kw motor on this vfd?

4 Answers  

---

what is the working principle of hydra step(electronic level indicator)?

2 Answers   Bengal Energy, Lanco,

---

how can you change unit of totalizer in siemens mag 5000 flow meter?

2 Answers   PowerTech,

---