Answer / shahbaz shaikh

in general motors are the machine which convert electrical energy to mechanical energy so if we want to convert motor to generator then we have to couple the motor shaft with some external turbine or d.c motor or pony motor so bye providing the high speed more then its synchronous speed we can make the motor as generator which have negative slip.

Answer / elvis luis

motors are machines which converts electrical energy to mechanical energy i.e it consumes electrical energy(supply source) and output is mechanical (torque) taken from the shaft output. motor,in case of induction motors, has a speed less than the synchronous speed and a positive slip. for a motor to run as a generator an external prime mover is used so that the motor is forcefully run above its synchronous speed. this allows the motor to run as a generator, in this case the motor now instead of consuming energy from the source starts feeding the source. a motor now acting as a generator has a negative slip.

difference between a four point starter and three point starter

9 Answers  

---

A T-T transformer can not be parallel with transformer A V-V B star-delta C star-star D delta-delta

1 Answers  

---

i seen a 132kv/11kv transformer,and thier is a sugar factorys 10MW EXPORT PLANT,MY QUESTION IS THAT WHEN THEY EXPORT ELECTRICITY THEY USE THE SAME TRANSFORMER AND THE CONNECT IT TO 132/11KV TRANSFORMERS SECONDARY SIDE CAN ANY ONE EXPLAIN IT.. THE TRANSFORMER IS OF KIRLOSKAR MAKE AND IT HAS TAP CHANGER.

1 Answers  

---

How to calculate fault level of 11 KV system

0 Answers  

---

what is frequency response?

0 Answers  

---

How a ship getting grounded

2 Answers   Deltin Jaqk,

---

What is the difference between CRNO and CRGO in an transformer and what is the advantages of these two.

13 Answers   Anchor, CIL, ETA, Kirloskar,

---

what is arc flash and what are the hazards involved

0 Answers   Reliance,

---

( Re: WHAT SHOULD BE THE RATING OF MCCB FOR 415V,3Ph,50KVAR CAPACITOR BANK Answer # 1 The capacitor current would be kvar x 1000 / (415 x sqrt3). This would be 70a approx. The MCCB selected should have *atleast 1.4 times this current i.e. 1.4 x 70= 98. So you should choose at least 100 A mccb.) regarding to this answer,i would like to know why the current have to times 1.4 to get the right amphere for the mccb.hows the formula to get the 1.4??tq

2 Answers  

---

how to syncronize two dg sets

3 Answers  

---

What is the function of electron gun assembly used in crt?

0 Answers  

---

Why do we use copper cable for HT Supply and why not Aluminium?

0 Answers  

---