Interested to Buy Any Domain ? << Click Here >> for more details...
How can we convert the motor to generator and also generator to motor
- 2 Answers
- 3883 Views
- Aesco, I also Faced
- E-Mail Answers
Answer Posted / elvis luis
motors are machines which converts electrical energy to mechanical energy i.e it consumes electrical energy(supply source) and output is mechanical (torque) taken from the shaft output. motor,in case of induction motors, has a speed less than the synchronous speed and a positive slip. for a motor to run as a generator an external prime mover is used so that the motor is forcefully run above its synchronous speed. this allows the motor to run as a generator, in this case the motor now instead of consuming energy from the source starts feeding the source. a motor now acting as a generator has a negative slip.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is making & breaking current ???
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
Define maximum demand?
Load break swicth maintenance procedure.
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
What is zero of the system?
why r we using shell transformer for low voltage
what type of earthing do for dry fissure rock?
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
Differentiate between Zero and Negative sequence current
What is the use of oil in transformers?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
