What are the different ratings of the fuse units for different distributions a

What are the different ratings of the fuse units for
different distributions at your organization?

Question Posted / ravi

3 Answers
26563 Views
TATA, UPPCL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What are the different ratings of the fuse units for different distributions at your organization?..

Answer / rajendran.m

2A,6A,10A,16A,25A,32A,63A,100A,125A,200A,250A.

Is This Answer Correct ?

10 Yes

3 No

What are the different ratings of the fuse units for different distributions at your organization?..

Answer / jigar1334

rating of fuse is not only in ampere but also in voltage otherwise after burning the fuse it wil flas over so voltage rating also important

Is This Answer Correct ?

4 Yes

0 No

What are the different ratings of the fuse units for different distributions at your organization?..

Answer / srinivas0699

2,4,6,10,16,25,32,50,63,80,100,125,160,200,250,315,400,630,800

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

briefly explain the main blocks found in a microprocessor based system

0 Answers

why causes the burnt of AC Electrical Motor ?

9 Answers

Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?

0 Answers

what is the role of transistor in Circuit?

0 Answers

why transformer does not obey ohms low?

3 Answers AITM,

what is the location of lighting switch of battery room

1 Answers

50 electric bulbs are connected across supply of 220 volts. After one bulb is fused remaining 49 bulbs are again connected to same supply. which case will have more illumination & WHY????????

5 Answers KJ,

What is the difference between AMF panel and DG Synchronization panel? please define the working of both the panels?

3 Answers ABB, Power Grid,

Where -48 volt DC use & why?????????

10 Answers Ericsson, INDUS, Indus Towers, Telecom,

Whot is the difference between MCB and MCCB.Whot is the selection critearea for MCCB and MCB for 63 Amp.

5 Answers

PLease anyone can tell me CTUM-15 specification?

1 Answers Gilbert Maxwell,

What is the minimum permissive IR value for LT & HT motor for safe starting?

1 Answers Rukmani,

For more Electrical Engineering Interview Questions Click Here