Answer / pammi.kumar@ymail.com

after some time regulater burn.

Answer / 1802.pranav

First of all every induction motor has a fixed Tem, i.e. Maximum Torque and to deliver 2000 watt of power a motor has to produce corresponding torque (Power=Torque* rpm). And N=120*f/P so rpm can be at max 3000 with 2 pole machine. So to develop 2000 watt of power it is the requirement of torque rather than simply the speed.

how to decide the ratings of the busbar in electrification.give me the proper thumb rule or procedure

1 Answers   ABB,

---

Why CT secondary is grounded?

4 Answers  

---

how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....

0 Answers  

---

Why the motor was take the starting current is high?

3 Answers  

---

purpose of check value

1 Answers   Seagate,

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers  

---

i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.

0 Answers  

---

why earthing point in the 6amps/16amps socket bigger than the remaining (Phase & Neutral)points.

1 Answers  

---

What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.

0 Answers  

---

how the characterstics of control valve being done

0 Answers  

---

what is unbalanced rotating magnetic field?

1 Answers  

---

Difference between low impedance and high impedance Restricted Earth Fault

0 Answers  

---