can i use the six sigma method which is used in management
area, in state estimation of power systems?
No Answer is Posted For this Question
Be the First to Post Answer
what is the difference between the diode and the rectifier
17 Answers Avalon, L&T, Mahacol Trexim,
lllg,llg,ll,lg,lll which fault is severe and why?
10 Answers COEP, GE, PSC,
ct connection of energy meter
WHAT ARE THE SITE TEST APPLIED ON A SURGE ARRESTORS? DO MEGGER TEST APPLIED ON SURGE ARRESTOR? IF YES THEN WHAT ARE THE ACCEPTED IR VALUE REQUIRED FOR SURGE ARRESTORS FOR VOLTAGE LEVEL 11KV, 33KV, 66KV 132KV, 220KV AND 400KV?
Why the motor take high starting current for long time(10- 15 sec) which is connected to Blower as compaire with a motor which is connected with pump with same rating?
What are HT & LT Cables? What are their values?
how to calculate cable size for the motor
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
What happen if in three phase 440 v , when you check voltage by testor it glows except one phase and in the same time when you check by multimeter it shows 440 v in any two phase.what will be the reason...
in india are trains run by DC or AC? if DC , from where it receives negative potential? because pentograph receives singe potential only?
how actually an anti pumping device works? what is the operational principal?
what is Micrologic 6.0A advantages over Micrologic 2.0A