Answer / k.prakashchandra

It may happen when NCT is not identical to line CTs

What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?

0 Answers   RasGas,

---

What are the motors used in a thermal power plant? (With type and ht/lt) What voltage levels are used in a thermal power plant?

2 Answers   OPG,

---

our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....

0 Answers   SWR,

---

What happens if there is no HP and LP By-pass.

5 Answers  

---

What do mean by 3t

1 Answers   Aman, Birla, Grasim,

---

---

In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?

3 Answers   TATA,

---

Why the steam Turbines are Designed Higher side compare to Alternator

1 Answers  

---

what is block out in thermal power plant?

3 Answers   SECL,

---

why drum level falls when one of the running coal elevations tripped?

3 Answers   APGenco,

---

why we use reduction gear box to reduce turbine high rpm to 1500 rpm in small plant

3 Answers   Maruti Suzuki, Sail,

---

What happens if air is present in LPH and HPH.

2 Answers  

---

How to decide Heating surface area of boiler on their steam generating capacity?

4 Answers  

---