Dear all... I have 1 0-400 duplex type RTD, I connected the A side to the temperature indicator and B side to the PLC panel, but when I have observed then found that The PLC side temp has the variation. and it was distub to other RTD temp also. so what can I do.pls help me

1 Answers   Worley Parsons,

---

why 4-20 mA signal is preferred over a 0-10V signal

17 Answers   Sofcon,

---

Name four general (not technical) criteria that would you consider important, when deciding upon a particular control valve?

1 Answers  

---

why pneumatic control signal output is use 0.2 to 1 kg/cm2

3 Answers   Jindal,

---

what is intrument termination what is commisioning

3 Answers  

---

PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear

0 Answers   MSL, SRAAC,

---

HI THIS IS NOOR AHMMAD.SHAIK, I AM WORKING IN INSTRUMENTATION MAINTENANCE Dept. in BOILER HOSE(BHEL HYDERABAD),,any other persons are working in same dept. i want some HELP in my subject

1 Answers  

---

how to install the Ph and Conductivity analyser? is there are any procedures which has to be maintained.

2 Answers  

---

Name different types of bourdon tubes.

0 Answers  

---

Which softwere is required to communicate the S7-300 processor

4 Answers  

---

What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?

0 Answers  

---

whatis virtual instrumention?

5 Answers  

---