why pneumatic control signal output is use 0.2 to 1 kg/cm2

Question Posted / nitin pandya

3 Answers
9855 Views
Jindal, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why pneumatic control signal output is use 0.2 to 1 kg/cm2..

Answer / shyam

Relation between nozzal flapper clearance and back pressure
is linear from 0.2 to 1kg/cm2 pressure range

Is This Answer Correct ?

21 Yes

1 No

why pneumatic control signal output is use 0.2 to 1 kg/cm2..

Answer / rana mujahid

starting from .2 is for live zero and .2 to 1 kg/cm2 is
because in this range the relation b/w flapper and nozzal
movment is linear,it was observed in starting of pneumatic
instrument after this it became standard....and still now
contineu

Is This Answer Correct ?

6 Yes

1 No

why pneumatic control signal output is use 0.2 to 1 kg/cm2..

Answer / tejas

This is a standard which ws derived when pneumatic
instruments were in world being a good relationship was
observed in a range of 0.2 to 1.0 Kg/cm2. however, large
size high pressure final control element cannot operate
with such a low pneumatic pressure and it leads to
discovery of pneumatic positioners

Is This Answer Correct ?

0 Yes

3 No

Post New Answer

More Instrumentation Interview Questions

Conversions

0 Answers CCIE, Nestle,

how we can check level probe and controller

2 Answers

What is the IEC Standard for PLC I/O Terminal wiring Procedure?

1 Answers

What is loop checking ?

10 Answers Kharafi National, Petrofac, Samsung,

1. How many output signals do wew have in process control? 2. Could you write down the names of the pre-commissioning and commissioning stage test instruments and explain them (more than 5 items)? 3. What is the first step to commission a transmitter on service? 4. What is RTD? 5. Find the output value in MA of a temperature transmitter (RTD Type) at 120degree celius? 6. What is the O/P signal of a pneumatic transmitter? 7. What is the O/P signal of an elctronic transmitter? 8. What is the close loop and open loon?

4 Answers

What is the procedure of DP switch calibration

2 Answers NOCL,

explain key exchanges in all security modes WPA,WPA2,TLS?

0 Answers

What are the type of bonnets in the control valves?

0 Answers CCIE,

Explain bernoulli’s theorem.

0 Answers

what is function test.

1 Answers Takreer,

Why using negative voltage in vibration measurement?

2 Answers

describe flow nozzel principle?

0 Answers SEWA,

For more Instrumentation Interview Questions Click Here