Answer / bidyut

coal consumption will be high.

Answer / anbu

May be coal consumption is high. And the major issue is that the temperature of flue gas may reduced to below the acidic dew point then the tube erosion will occur in economiser coils and ESP also will disturb like lesser efficiency due to low charging performance.

Acidic dew point means that, H2So4 phase change occur from gaseous state to liquid state.

Answer / selvalagan

Air pre heater air outlet temperature will be high and Economiser outlet water temperature is low.



So boiler efficiency is become low.

Answer / dk

satuated temperature very low temperature and air heater outlrt air & pa air also hot air above 200c and fuel consumption not high as possible only reason for economiser o/l temperature only decreased

Answer / syed

Drum itself hammering will happen due to low inlet temperature also desuperheater coil damage due to low water temperature

Answer / shivaling naik

For water temperature increasing....

Which will have more strain energy 1.Spring 2.Circular disc 3.Solid square plate.

0 Answers  

What is indipendant power plant

4 Answers   TVS,

.What is drip and drain.

2 Answers   NPTI,

whatis means of PPA & FSA OR SFA in power plant operation

2 Answers  

a gas turbine have how many thermocouples?

2 Answers   DEWA,

how shall you calculate PLF on the basis of percentage auxillary load factor

6 Answers  

What is df/dt protection?, How to calculate setting range of 30 MW steam generator???

1 Answers   DS Sugars, MEMF,

What do mean by 3t

1 Answers   Aman, Birla, Grasim,

What is MFT and when it is acted.

2 Answers   HPCL,

how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?

0 Answers  

our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....

0 Answers   SWR,

How to calculate air to fuel ratio in boilers

1 Answers