Answer / vinoth.s

CAL MODE, normally during transmitter calibration or
maintenance, we used to put it in CAL mode which give its
last value as a reference value for the controller. So that
we can calibrate or do maintenance for our transmitter
without any disturbance to the process controller

Answer / bala murali/ramesh

CAL Mode used in instrument/sensor/transmitter maintenance/repair/calibration time.In that time we can give some reference value which is for normal control operation.

Calibration means sensor/transmitter response calibration for required range.

what is water consumption rate of water to condense one ton steam in condensor.

1 Answers  

---

A 5A rewirable fuse blows when 9A flows.determine the fusing factor?

1 Answers   Schneider, Student, Tata Power,

---

What is difference between secondary Air & Tertiary Air and Their use.?

0 Answers   Bhel,

---

I want to build 100 megawatt hydel dam. What does mean, 100 MW per hour? then how many electric bulb of 100 Watts the dam would lit?

1 Answers  

---

What will happen if the Air Preheater is placed before the Economiser?

6 Answers   Bhel, KSPL, Tata Power,

---

why do we use contro fluid tank (cft)in turbo generator area(tg) in power plant?

1 Answers   MPL,

---

What will happen if id fan on boiler not functioning?.Can the Boiler run without id fan? What is the effect?

4 Answers  

---

What is MFT and when it is acted.

2 Answers   HPCL,

---

What is the use of Hydraulic Coupling in-between BFP pump & BFP Motor?

1 Answers   Lanco, XYZ,

---

Can any one advised me how we can measure the losses in a 11kV/415v power transformer? We have no access to the incoming mains into the primary of the transformer. Can one derive something useful by measuring temperature rise in the transformer?

1 Answers   Dexdyne,

---

what is CT saturate?and which effect on CT after its saturate?

4 Answers  

---

what is interview question for power plant

3 Answers   Emerson, IOCL, SBPIL,

---