Answer / powerplant.calculations

As a rule of thumb Around 65 MT of cooling water is required to condense the steam at rated vacuum.

Refer below link for more information
https://www.powerplantandcalculations.com/2020/05/steam-condenservacuum-and-calculations.html

What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?

0 Answers   RasGas,

---

How to calculate air to fuel ratio in boilers

1 Answers  

---

what is under voltage protection 27

1 Answers   CLP, NCC,

---

why the steam turbine is not operated in home(base) load more than 1 hour kindly calrify

4 Answers   TATA,

---

what is the formula for converting mmwc to tph in a dp type transmitter.what is the range in plc(in tph) if dp tx.range from 0 to 5000mmwc.

2 Answers   CCC, Korba Power Plant, Shyam Steel, Utkal Alumina International,

---

what is IR in differential test on motor?

2 Answers   Adani, Adani Power,

---

What is LB-SR.

0 Answers  

---

I want to build 100 megawatt hydel dam. What does mean, 100 MW per hour? then how many electric bulb of 100 Watts the dam would lit?

1 Answers  

---

What are the turbine protections.

2 Answers  

---

2. what is meant by exhausthood temp?

4 Answers   Alstom, ANG, GMR,

---

what is the difference between compensated & normal drum level in boiler drum?

0 Answers   ARS,

---

DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.

0 Answers  

---