Answer / shounak mandal

start
n1=0 n2=0 temp=0
read n1 and n2
temp=n1
ni=n2
n2=temp
print n1 and n2
stop

Dont forget to use flow chart symbols

what is the essential difference between DIODE and SCR in term of application.

2 Answers   ADMA OPCO,

---

What is the cascade control

0 Answers  

---

I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?

0 Answers  

---

How to calibrate a orifice differential pressure flow transmitter in process?

1 Answers  

---

which type of zones used for boiler? & why ?

0 Answers  

---

WHAT IS SMART SENSOR AND DIFFERENT B/W SMART SENSOR AND SENSOR??? PLS GIVE ME ANSWER AS SOON AS POSSIBLE.....

1 Answers  

---

how to connect 3 wire 4-20 mA transmitter in Plc system PLC system and how explain how the measuring data communicate with plc system.

1 Answers  

---

how to make a calibration for differential pressure

2 Answers  

---

Consider a control valve action,the inlet air pressure is only 6 ksc but physically how it can be operate against 100 ksc line fluid pressure?

2 Answers   SCS,

---

How much voltage we are using at switches?

4 Answers   Edac,

---

For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.

0 Answers  

---

what is mean by hot loop and cold loop testing, whts different between both

2 Answers   Honeywell, PDO,

---