how to draw a flowchart for swapping two numbers using bit
wise operators?
- 1 Answers
- 8790 Views
- I also Faced
- E-Mail Answers
Answer Posted / shounak mandal
start
n1=0 n2=0 temp=0
read n1 and n2
temp=n1
ni=n2
n2=temp
print n1 and n2
stop
Dont forget to use flow chart symbols
| Is This Answer Correct ? | 7 Yes | 5 No |
Post New Answer View All Answers
any body please send me the old question papers of ongc test.
it is possible to check the fail safe condition in pressure transmitter. if possible how?
What is the use of single seated valve?
if in a level tx height is given, how u calculate the ranges of the tx?
steps for installing orifice plate?
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
what is the procedure of belt scale calibration?
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
How flow can be measured with dp?
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
can we create an interrupt in plc through scada?
If P will increase then what will happen with PID?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
