.how does CSADA systems display the process variable value?

Question Posted / lee

2 Answers
5083 Views
Empower, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

.how does CSADA systems display the process variable value?..

Answer / sathish

it depend on our requirement we can display it using graphical
form or using numerical viewer

Is This Answer Correct ?

2 Yes

0 No

.how does CSADA systems display the process variable value?..

Answer / prahalad prajapat

using communication software like as RsLinks software which
communicate between programming CSADA

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

what is the difference between mmhg & mmwc?. i want to calibrate a transmitter in the range of -100 to 300 mmwc. Which is the reference for calibrate the Tx,if mmwc not available?. Is it mmhg or mmho2?.

3 Answers UPL,

what is the difference b/w normal thermocouple and skin type thermocouple?

1 Answers Heisco,

can you send remote seal interface level transmitter calculation steps for oil water saperator.

0 Answers Sasol Firm, Thermax,

in differential pressure transmitter,min&max pressure range for hp&lp

0 Answers

Define all the process Variable and state their unit of measurement. ?

0 Answers

HOW TO CALIBRATE A PRESSURE SWITCH?

7 Answers

Which buffer solution is used for PH transmitter calibration?

3 Answers

Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?

0 Answers ISRO,

what do you mean by smart instruments?explain with example

4 Answers

What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller

0 Answers

what is the difference between(Flame proof/Explosion proof)& Fire proof instruments.Both are same or different & if different in which way because the transmitter which have approved ATEX flame proof enclouser but it use PTPE O ring & PTFE Head Gasket,so its (fire safe/fire proof)????????

4 Answers

Hi friends, from Aug 4th onwards iam getting spikes for analog inputs in our DCS for a period of 800ms. I throughly checked every thing, finally i found that the DI, DO's from MCC panels shields are terminated in the Signal Earth where Analog Input signals shields are terminated. Is there any problem with this type of termination?. i checked the induction voltage from MCC and getting around 25VAC, please suggest me in this concern. Our plant is 8months old only. DCS is Siemens Make Simatic PCS7, and the transmitters are Yokogawa make.

1 Answers

For more Instrumentation Interview Questions Click Here