Answer / nirmal

It functions by having two parallel tubes both containing
gas and heating coils. The gases are examined by comparing
the rate of loss of heat from the heating coils into the
gas. The coils are arranged in a bridge circuit so that
resistance changes due to unequal cooling can be measured.
One channel normally holds a reference gas and the mixture
to be tested is passed through the other channel

How to calculate mmwc values into tonnes?

0 Answers  

---

What is fault tolerent system

2 Answers   GNFC,

---

How can we say that accuracy of measurement increases by using 3 or 4 wire RTD? because for example: If resistance of RTD element is say r ohms and Resistance of the cable from transmitter to RTD is R ohms And if 4 wire RTD is used, ____._____________________ R ohms | |_____._____________________ R ohms / \ / r ohms \ \ | |______.__________________ R Ohms | |_______._________________ R ohms Then the actual resistance measured will be: Total = r + R/2 + R/2 = r +R Ohms Note: r+R instead of r ohms. hence error

2 Answers  

---

If I want to buy a pressure switch & 3-way valve for hot water application then witch parameter I should consider.

1 Answers  

---

What is open loop and close loop?

4 Answers   L&T, Pearl Distillery,

---

why we are using -24 vdc in plc?

1 Answers   CGL,

---

What is the Temperature Co-officient of Resistance of PT- 1000 and PT-2000 ?

2 Answers   Adani, Birla, MEIL,

---

what is interlock ckt? why it is necessary in industrial machines ?

2 Answers   IOCL,

---

what is span value and zero ? and how set ?

0 Answers  

---

draw the block diagram of a level transmitter ?

0 Answers   Hira Group, Samsung,

---

how to know power plant process with corresbonding laws&thoeries

1 Answers   Bhel,

---

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---