What is 3 selection available when configure the burnout protection for controller
No Answer is Posted For this Question
Be the First to Post Answer
What is the difference between rich gas and lean gas?
Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify
what is difference b/w the solinoid volve and autodrain?
what is the hydra step level sensor output value( measuring level of steam drum)
Describe how to use megger to measure the earth resistance and insulation resistance
What does a fire detector detects?
What do you know about gail?
How to Calibrate Flow Switch in field
Reasons for using current as signal
how to calibrate an error for pressure transmitter, make it easy to understand
WHAT IS TSI? HOW ITS WORK
On liquid service if PT Head is 18 meters. How much pressure will be exerted on it. If Transmitter is not in service?