Answer / jobby c johnson

Distance is not a limiting factor for current transmission(4-20mA) where as it is a limitation for voltage transmission. Because based on the resistance the signal seeing there will be a voltage drop. then the voltage signal available at the host end will not be same at the generating side. Based on the distance these deviation will be more.

Answer / sayuk

1000km

Answer / satya

it is depend on voltage drop between instrument and dcs,
beacuse resistance increases,minimum 80% of rated voltage is
allowed after that may be instruments showing wrong value .

hello dear i have faced problem in drum level transmitter. the problem is when i engrize the meter meter shows 100% but the actual level 40 or something plz suggest me

7 Answers  

---

what is dry leg and what is wet leg?

3 Answers  

---

what is hot loop check and cold loop check.

3 Answers   Bapco Bahrain Petroleum Company,

---

how u measure flow?orifice measurement?why all ft in square root?

1 Answers  

---

3element

2 Answers  

---

when a magnet is heated?

0 Answers  

---

How will u convert the mmh2o in mass or Volumetic flow rate in DP Flow Transmitter. Give me the Brief explain using the formula

1 Answers   Walchandnagar Industries,

---

why level transmitter input is given 4to20ma

2 Answers   Sabic,

---

what is the procedure to isolate flow a transmitter and flushing it?

8 Answers   Petrofac,

---

Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?

0 Answers   Process Control Technologies,

---

Shall we get the reading on level transmitter only by termination,without commissioning?

1 Answers  

---

1. How can leveltrol be installed in steam drum for measuring the level of steam drum?

1 Answers   Fischer,

---