I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.

0 Answers  

---

What is Positive Calibration and Negative Calibration?

0 Answers   SA Kent,

---

i am working in thermal power plant . if temperature transmitter is not showing reading in dcs then how can we rectify the problem?

8 Answers   TATA,

---

what is formula for calculating flow if i have pressure and pipe diameter?

1 Answers  

---

How to calibrate level switch?

2 Answers   Power Plant, Sabic,

---

what is the difference between sensor and tranducers?

12 Answers  

---

How u measure the massflow in orifice flow measurement techniques

0 Answers   Johnson Matthey,

---

How many types of sensor

0 Answers   Petro Rabigh,

---

warning lamp does not light, but it does light when the wire from the lamp going to the sending unit is grounded (the part that plugs into the sending unit) what does this indicate)?

1 Answers  

---

what is the deluge ? How can its working?

2 Answers   KOC,

---

what is moisture probe? What are there types? What is there working principle and how they works? guys this is one of technical question I had ask in interview. If you know its answer please let me know. The interviewers were more interested in microwave moisture probe, so if you find its any link please just forward me on my mail id.avinash1200@gmail.com Thanks in advance.

0 Answers  

---

how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???

0 Answers   Siemens,

---