Answer / arun

to execute one bit of instruction the microcontroler takes the 12 clock
pulses
and to execute the one charcter it takes 32 clock pulses .so it is divided.

what is the working principle of hydra step(electronic level indicator)?

2 Answers   Bengal Energy, Lanco,

---

Why we not use 2-20Ma or 1-20Ma

5 Answers  

---

I have a steam flow DP transmitter that has output swinging. Steam valve is in manual.I have good steam pressure. The impulse lines have steam tracing on them. The steam tracing has a hole in it that is blowing raw steam on the high side impulse line only. Could this be causing the swinging?

1 Answers   Honeywell,

---

what are procedure of sox-nox calibration

0 Answers   TATA,

---

NAME ANY TWO ELASTIC PRESURE SENSOR?

2 Answers   DVC,

---

p=hdg,please explain these parameters?

7 Answers  

---

Reasons for using current as signal

1 Answers  

---

What are the disadvantages of Human-Machine Interface (HMI)? atleast 3.

1 Answers  

---

should I use Hydrostatic Pressure Transmitter for measurement of DENSITY of filled tank ? If YES then please explain how.

2 Answers   HPCL,

---

What is the difference between DCS and SCADA?

1 Answers  

---

What is Trim?

1 Answers   Gujarat Borosil,

---

How much should be the values and/or percentages of these given below factors for a good controller ? Steady state error Delay Rise Time Overshoot Peak Time Settling Time Damping Oscillations & vibrations thanks

1 Answers  

---