Answer / chennurupavanireddy

we can improve power factor by connecting capacitors in
parallel with the circuits so that they compensate lagging
components and improves the power factor there by the
efficiency of the circuit increases.

Answer / chetan

KVAR Required is

KVAR = P [tan (phi 1) - tan (phi 2) ]

where P = total KW
phi 1 = angle corresponds to power factor to be improved . ie cos ph 1 = 0.9

phi 2 = angle corresponds to power factor given . ie cos ph 2 = 0.7

Answer / vijay patel

We Can improve power factor (1)by using shunt capacitors (2)
By using phase advancer (3)by using synchronous condenser

Answer / k.prakashchandra

KVA^2 =KW^2 + KVAr^2. Reduce KVAr to improve pf

Answer / khalid mohammed yousf

S=V.I (AV)
S = (P^2 + Q^2)^(1/2)
cos ϕ =S/P
Q=(S^2-P^2)^(1/2)
Q=(E^2)/X
C=(1/2*PI*F*Xc)
C IS shunt capacitor using to improved power factor

What are the advantages of nichols chart?

0 Answers  

How you take care of a motor from over loading and what are the different overloading ratings of different motors?

4 Answers  

What the reson for frequant instantaneous ground over current fault in our sync. Generator... 15 triping in 24 hr...

1 Answers   HCPL, Jhunjhunwala Vanaspati Jhoola, Regen Powertech,

draw a dol with the following rtds,stop/start,ct,vt and o/l supply is 6.6kv and the coil is 110v

1 Answers   Anglo Eastern,

Explain in brief description about the operation of DG sets.

0 Answers   Siemens,

What is the difference between Contactor and Circuit breaker ?

8 Answers  

What will be result if we connect LT votage to the terminal of HT Transformer?

3 Answers   Equate,

how to calculate the distance relay faulty zone?pls explain?

0 Answers  

How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.

0 Answers  

what solid earthing means?

3 Answers  

where do we connect tap of tap changer, to H.V. side or L.V.side? and why?

5 Answers   Vedanta,

sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....

0 Answers