what is the difference between relay, contactor
Answers were Sorted based on User's Feedback
Answer / umairalikhan357@gmail.com
relay is that device which make or break cntact and relay oprate on signal and contactor is caterixed
| Is This Answer Correct ? | 5 Yes | 0 No |
Answer / jaswinder singh
relay is low current device. and contactor is high current device.
| Is This Answer Correct ? | 4 Yes | 1 No |
Answer / sserwadda tom
A relay is suitable for switching small current and voltages where as a contactor is suitable for switching high electric current and voltages.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / p.manikandan
relay and contactor is same current device.but relay bimetalic strip is over load current fault this circuit triping movement. so motor connection cut motor saving
| Is This Answer Correct ? | 0 Yes | 0 No |
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
definition of fault level in powersystems?
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
how many types of dc batteries standards are present?
How can decide the MVA rating of power transformer for substation like 220/132, 132/66, 66/33kv etc or even higher kv rating of substation???? Send me the strictly technical answer that shows your strong technical aptitude.
what is the difference between indoor & Out door substations
improve power factor by : 1)shunt reactor 2)shunt capacitor 3)series capacitor 4)series reactor
I am looking for LV CT test. To check the polarity of the CT only. Can you suggest any supplier. Different companies are offering CT/PT Tester which is expensive. Thanks
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
At what voltage domestic tubelight works?
what is phase to phase to phase to ground fault
why firewall is build up between two transformer (220/11kv,50MVA)?what should be the firewall height?what is the clearance between firewall and transformer?
2 Answers Siemens, Tous Stadt,
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)