Answer / kamlesh kothari

we are using 50 hz frequency in india and we do not use
other frequencies like 52,59,42 etc because of our national
electrical power is 50 hz basis and all power generators or
equipment and plant designed on 50 hz frequency.

Answer / kj

Other then it being the standard it is because the rpm of
machines is set by the frequency. To generate 50 Hz the
generator must run at 3000, 1500, 1000, rpm depending on
the number of poles (2, 4 and 6). At 52 hz it would be
3120, 1560, 1040 rpm.

Answer / shahbaz shaikh

at the power station the generator turbine set for 50 hz and our electrical system is designed for 50hz frquency and as we know that all type of losses are depends on frequency if it is more then losses increases and also motor goes to saturation, hormonics hence we use 50hz frequency in india and not other frequencies
like 52,59,42

Answer / mohammed ajmal

In India almost every electronic equipments are made for the frequency of 50 Hz.... If the frequency increased or decreased...It will cause damages to the electronic equipments..

Answer / ramesharavind s

because we are at starting only in 50 hz so all power make
50hz module generator and motor.

How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?

0 Answers  

When is lag lead compensator is required?

0 Answers  

explain transformer ct connection?

0 Answers  

what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network

1 Answers  

HAT IS THE EFFECT OF LOW POWER FACTOR ON THE GENERATING STATION?HOW WILL YOU IMPROVE THE LOW POWER FACTOR?

1 Answers  

when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??

0 Answers  

What effect of supplying stationary generator (800kVA) with 415V AC from 1500kVA transformer?

2 Answers  

what instruments used for measuring of inductance and capacitance.

2 Answers  

Grounding. Dear all at one of my site we checked the amps at the earthing cable to the alternator it was found 125 to 130 A. at the neutal cable in same machine found 146A. in the same plant checked the earthing current on other alternator it was 52A, and neutral 116 A. we are facing problems with our controller and the card was damaged once. can that neutral/GND current be a reason? as there is common grounding for the Alternator,Brkr panel,Transformer?

2 Answers  

what is difference between tension tower and suspension tower?

8 Answers  

what is smart&micro grid technology?under coal gassification?

0 Answers  

The rotor current is directly proportional to slip. How?

3 Answers